Steps
1. Insert a flat-head screwdriver in the dummy optional-I/O module bracket.
2. Push the bracket to release the bracket from the chassis.
3. Connect the I/O-module cable to the connector on the system board.
4. Insert the I/O module into the slot from the inside your computer.
5. Replace the two screws (M3x3) to secure the optional I/O module to the chassis.
NOTE:
The screw type differs with the kind of I/O module used.
6. Place the computer in an upright position.
Next steps
1. Install the
.
2. Install the
.
3. Install the
.
after working inside your computer
.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
before working inside your computer
.
2. Remove the
.
48
Removing and installing components