Dell PowerVault TL1000, User Manual, Page: 59 / 192

Configuring trap notifications
Note: This procedure is optional. SNMP notifications are not enabled unless there is a check mark in the
SNMP Enabled check box. To disable SNMP notifications, clear the SNMP Enable check box and click
Submit .
The traps that are supported by the TL1000 Tape Autoloader are listed in “Trap definitions (types)” on
page 128.
To set up trap notifications for an SNMP server:
1. Expand Configure Library, if necessary, and click Notifications in the left navigation pane of the Web
User Interface.
2. Click the SNMP Settings tab.
3. Click to place a check mark in the SNMP Enabled check box.
4. Configure the SNMP server and header settings.
v Community - SNMP community name to which the library belongs.
v Name - Unique SNMP name for the system.
v Location - Physical location of the system.
v Contact
- Contact person's name.
v SNMPv3 engine ID - A read-only attribute that identifies the SNMPv3 engine.
5. Enter the trap IP addresses of the SNMP monitoring stations to be notified when an event takes place
and the security settings in the Trap List menu.
a29z0128
Figure 39. Trap notifications
Installation and configuration
41