Dell PowerVault TL1000, User Manual

Page: 46 / 192

1. Attach an ethernet cable to the ethernet port (
▌1▐
in Figure 27)
Note: On rack mount installations, run the cable through the hook-and-loop fastener strap on the
right rear bracket.
2.
Attach the host end of the SAS cable to the drive’s SAS connector (
▌2▐
in Figure 27). See “SAS host
interface” on page 5 for information about the type of SAS connector that is required for attachment
to the drive.
Note: On rack mount installations, run the cable through the hook-and-loop fastener strap on the
right rear bracket.
3. Attach the other end of the host SAS interface cable to the host or to an interposer if required.
4.
v Method 1: Plug the ethernet cable into your server or PC to access the Web User Interface directly.
This method modifies your server or PC network settings to match the library default settings. You
can also use the library Operator Panel to change the library network settings to match the server
or PC network settings before you use the Web User Interface to access the library. If the ethernet
connection is directly attached to a server or a PC, a crossover ethernet cable might be required.
v Method 2: Plug the ethernet cable into an ethernet switch or router to access the Web User Interface
on a LAN (local area network). The library network settings must be entered with the Operator
Panel before the Web User Interface is used to access the library.
Connecting the power cord
Important: This product can ONLY be used with an approved power cord for your specific geographic
region. Use of an unapproved power cord might result in
v Not meeting individual country-specific safety requirements
v Overheating with potential personal injury or property damage
v A fracture that results in internal contacts that are exposed, which might subject the user to a shock
hazard
To connect a power cord:
a29z0100
1 2 3
Figure 27. Interface cable connection
28
Dell PowerVault TL1000 Tape Autoloader: User's Guide