Dell PowerVault TL1000, User Manual

Page: 39 / 192

Installation and configuration
“Choosing a location”
“Installing in a rack” on page 22
“Removing the accessor locking screw” on page 27
“Attaching the library to a server” on page 27
“Configuring your library with the Web User
Interface” on page 31 “Logging in to the Web User Interface” on page 31
“Checking firmware level” on page 33
“Configuring library settings” on page 34
“Configuring network settings” on page 35
“Configuring date and time settings” on page 36
“Configuring encryption settings” on page 37
“Configuring email notifications” on page 40
“Configuring trap notifications” on page 41
“Managing user access” on page 43
“Saving the library configuration” on page 45
“Configuring your library with the Operator
Panel” on page 45 “Logging in to the Operator Panel” on page 45
“Configuring network settings” on page 46
“Configuring library settings” on page 47
“Populating the library with cartridges” on page 48
“Verifying library and drive operation” on page 49
“Taking the Library Online” on page 50
“Registering for support notification” on page 50
To install and configure a TL1000 Tape Autoloader, complete these procedures in the order they are
presented.
Choosing a location
Table 12. Location criteria
Criteria Definition
Room temperature 16 - 32 °C (60 - 90 °F)
Voltage 100 - 240 Vac. (4.0 to 1.5 A)
Note:
The power switch is on the rear of the library and
must be easily accessible.
Frequency 50 - 60 Hz
Relative humidity 20 - 80% non-condensing
Air quality The library must be placed in an area with minimal
sources of particulate contamination. Avoid areas near
frequently used doors and walkways, stacks of supplies
that collect dust, printers, and smoke-filled rooms.
Excessive dust and debris can damage cartridges and the
tape drive.
21