The following table shows the physical layout of the fans as seen from the front of the system.
Left fan assembly
Right fan assembly
Fan 1
Fan 2
Fan 3
Fan 4
Fan 5
Fan 6
Extend the system from the cabinet
Use this procedure to extend the system from the cabinet so that you can remove the system cover to access the internal FRU
components, or to remove the system from the cabinet.
Steps
1. At the front of the cabinet, locate the two slam latches on the left and right sides of the system. Pull the slam latches up to
release the system from the cabinet. If the slam latches do not disengage, loosen the screw under each latch.
2. Using the slam latches, pull the system from the cabinet until the rails lock in the extended position.
Remove the system cover
Steps
1. Using a flat or a Phillips head screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
2. Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the
system.
3. Hold the cover on both sides, and lift the cover away from the system.
Replace a Fan
25
