3.
If disconnected, reconnect the cables to the expansion card(s).
4.
Install the cooling shroud.
5.
While booting, press F2 to enter System Setup and verify that the processor information matches the
new system configuration.
6.
Run the system diagnostics to verify that the new processor operates correctly.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing the processor
Removing a heat sink
Installing the cooling shroud
After working inside your system
Installing a heat sink
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Keep the Phillips #2 screwdriver ready.
4.
Install the processor.
Steps
1.
If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean
lint-free cloth.
2.
Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on
the top of the processor.
CAUTION: Applying too much thermal grease can result in excess grease coming in contact
with and contaminating the processor socket.
NOTE: The thermal grease syringe is intended for one-time use only. Dispose of the syringe
after you use it.
172
