CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2
Use a plastic scribe to pry out the system battery as shown in the following illustration:
Figure 143. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 144. Installing the system battery
Next steps
1
Install the expansion card riser 1A.
2
If applicable, connect the cables to the expansion card(s).
3
If applicable, open the PCIe card holder latch on the air shroud to secure the full length expansion card.
4
Follow the procedure listed in
After working inside your system
.
5
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
6
Enter the correct time and date in the System Setup
Time
and
Date
fields.
7
Exit the System Setup.
Related link
Opening and closing the PCIe card holder latch
Removing expansion card riser 1
Installing expansion card riser 1
Internal USB memory key (optional)
An optional USB memory key can be installed in the internal USB 3.0 port and can be used as a boot device, security key or mass storage
device.
The internal USB port is on the system board.
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Related link
System board jumpers and connectors
Installing and removing system components
185
