•
To ensure adequate cooling when one or more GPUs are installed, the ambient inlet temperature is restricted to 30°C for CPU 150 W/8
C, 165 W/12 C, 200 W, 205 W. For more information, see the ambient temperature limitations section.
•
Ensure that the GPU enablement kit is available.
The GPU enablement kit includes:
•
GPU air shroud
•
Mylar
•
Riser 3A
•
GPU cable for riser 3A
•
GPU cable for riser 2A
•
Riser 2A
•
Riser 1A or 1D
•
GPU cable for riser 1A or 1D
•
Two 1U processor and heat sink modules and two CPU clips
•
Six high performance cooling fans
•
All GPUs must be of the same type and model.
•
You can install up to three double-wide or six single-wide GPUs.
•
The filler bracket on the GPU air shroud must be removed before installing the GPU.
•
Ensure that high performance fans and GPU air shroud are installed.
NOTE:
When using systems with GPU, ensure that you install PSUs with 1100 W or higher, and set the PSU configuration to non-
redundant mode.
Removing a GPU
Prerequisites
1
Follow the safety guidelines listed in
.
2
Follow the procedure listed in
Before working inside your system
.
3
Press the blue tabs on either sides of the shroud and remove the top cover of the GPU air shroud.
Installing and removing system components
145
