Figure 88. Installing expansion card riser 1
Next steps
1
If removed, install expansion cards into the riser.
2
Follow the procedure listed in
After working inside your system
.
3
Install any device drivers required for the card as described in the documentation for the card.
Related link
Installing expansion card into expansion card riser
Removing expansion card riser 2
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4
If installed, remove expansion cards installed on the riser.
5
Remove the air shroud.
6
Disconnect any cables connected to the riser.
Steps
1
To remove expansion card riser 2A:
a Using Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
b Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
140
Installing and removing system components
