Dell PowerEdge M600, Hardware Owner'S Manual

Page: 66 / 236

66
About Your System
System Messages
Table 1-18 lists the system messages that can occur and the probable cause
and corrective action for each message.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
NOTE:
If you receive a system message that is not listed in Table 1-18, check the
documentation for the application that is running when the message appears, or the
operating system's documentation for an explanation of the message and
recommended action.
Table 1-17. Ethernet Pass-through Module Indicators
Indicator Type Pattern Description
Link
indicator/activity
indicator Green on,
amber
blinking The Ethernet connector is linked to the blade and
there is network activity.
Green on,
amber off The Ethernet connector is linked to the blade and
there is no network activity.
Green off,
amber
blinking The Ethernet connector is not linked to the blade
and there is network activity.
Green
off/amber off The Ethernet connector is not linked to the blade
and there is no network activity.
Power indicator Off Power to the module is off.
Green Module has power.
Status/
identification
indicator Blue on Active module.
Amber
flashing Fault condition in module.
NOTE:
Ethernet media speed is configured through the blade LOM firmware or by the
operating system. Speed and duplex settings are not configured through the pass-
through module itself.