Dell PowerEdge H730P, User Manual

Page: 29 / 101

10. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
Figure 2. Removing and Installing the PERC H730P Card
1. SAS cable connector (2) 2. card battery
3. PERC H730P card 4. clamp
5. card connector on the system board 6. clamp slots on the power supply bay
Installing The PERC H730P Card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
2. Open the system.
3. Remove the NDC riser.
4. Lift the clamp attached to power supply bay and locate the PERC H730P card connector on the
system board.
CAUTION: To prevent damage to the card, you must hold the card by its edges only.
5. Align the card-edge connector with the connector on the system board.
6. Press the card-edge down until the card is fully seated.
29