Dell POWEREDGE 4300, Installation And Troubleshooting Manual

Page: 40 / 217

3-10 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
1-3-2
1-3-3
1-3-4
1-4-1
1-4-2
2-1-1
through
2-4-4
No memory installed
Chip or data line failure in
the first 64 KB of main
memory
Odd/even logic failure in
the first 64 KB of main
memory
Address line failure in the
first 64 KB of main
memory
Parity failure in the first
64 KB of main memory
Bit failure in the first
64 KB of main memory
Remove and reseat the DIMMs. If the
problem persists, replace the DIMMs. See
“Adding Memory” in Chapter 8 for instruc-
tions on installing or removing DIMMs. If
the problem still persists, replace the sys-
tem board. See Chapter 11, “Getting
Help,” for instructions on obtaining techni-
cal assistance.
3-1-1
3-1-2
3-1-3
3-1-4
Slave DMA-register
failure
Master DMA-register
failure
Master interrupt-mask
register failure
Slave interrupt-mask
register failure
Replace the system board. See Chapter 11,
“Getting Help,” for instructions on obtain-
ing technical assistance.
3-2-4 Keyboard-controller test
failure Check the keyboard cable and connector
for proper connection. If the problem per-
sists, run the Keyboard Test Group in the
Dell Diagnostics to determine whether the
keyboard or keyboard controller is faulty.
See Chapter 5, “Running the Dell Diagnos-
tics.”If the keyboard controller is faulty,
replace the system board. See Chapter 11,
“Getting Help,” for instructions on obtain-
ing technical assistance.
3-3-1 CMOS failure Run the System Set Test Group in the Dell
Diagnostics to isolate the problem. See
Chapter 5, “Running the Dell Diagnostics.”
7DEOH6\VWHP%HHS&RGHV FRQWLQXHG
&RGH &DXVH &RUUHFWLYH$FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.