I/O Ports and Connectors
151
Figure B-7.
NIC Connector
Network Cable Requirements
The NIC supports a UTP Ethernet cable equipped with a standard RJ45-compatible plug. Observe
the following cabling restrictions.
NOTICE:
To avoid line interference, voice and data lines must be in separate sheaths.
•
Use Category 5 or greater wiring and connectors.
•
Do not exceed a cable run length (from a workstation to a hub) of 100 m (328 ft).
For detailed guidelines on operation of a network, see "Systems Considerations of Multi-Segment
Networks" in the IEEE 802.3 standard.
Table B-7.
NIC Connector Pin Assignments
Pin
Signal
I/O
Definition
1
TD+
O
Data out (+)
2
TD–
O
Data out (–)
3
RD+
I
Data in (+)
4
NC
N/A
No connection
5
NC
N/A
No connection
6
RD–
I
Data in (–)
7
NC
N/A
No connection
8
NC
N/A
No connection
link indicator
activity indicator
Summary of Contents for PowerEdge 1800
