Dell PowerConnect M6220, User Configuration Manual

Page: 879 / 1294

Configuring Routing Interfaces
879
Configuring Routing Interfaces (CLI)
This section provides information about the commands you use to configure
VLAN routing interfaces, loopbacks, and tunnels on the switch. For more
information about the commands, see the
PowerConnect
M6220/M6348/M8024/M8024-k CLI Reference Guide
at
support.dell.com/manuals .
Configuring VLAN Routing Interfaces (IPv4)
Beginning in Privileged EXEC mode, use the following commands to
configure a VLAN as a routing interface and set the IP configuration
parameters.
Command Purpose
configure
Enter Global Configuration mode.
interface vlan vlan-id Enter Interface Configuration mode for the specified
VLAN.
ip address {dhcp | none
| ip_address subnet_mask
[ secondary ]}
Configure the IP address.
Use the
dhcp keyword to enable the DHCP client and
obtain an IP address from a network DHCP server. Use
none
to release the address obtained from the DHCP
server.
Use
ip_address and subnet_mask to assign a static IP
address. If you configure a static address, you can use
the
secondary
keyword to specify that the address is a
secondary IP address.
ip netdirbcast Enable the forwarding of network-directed broadcasts.
encapsulation {ethernet |
snap}
Configure the link-layer encapsulation type for the
packet. Routed frames are always ethernet encapsulated
when a frame is routed to a VLAN.
ip proxy-arp Enable proxy ARP on the interface. Without proxy ARP,
the switch responds to an ARP request only if the target
IP address is an address configured on the interface
where the ARP request arrived. This command is not
available in interface range mode.