Dell PowerConnect 7000 Series, Reference Manual

Page: 966 / 1730

966
IP Routing Commands
The addition of a preference option has a side benefit. The preference option
allows the operator to control the preference of individual static routes
relative to routes learned from other sources (such as OSPF). When routes
from different sources have the same preference, PowerConnect routing
prefers a static route over a dynamic route.
Static Reject Routes
To administratively control the traffic destined to a particular network so that
it is not forwarded through the router, PowerConnect enables configuring a
static reject route for that network on the router. Such traffic is discarded and
the ICMP destination unreachable message is sent back to the source. Static
reject routes are typically used to prevent routing loops.
Default Routes
PowerConnect routing provides a preference option for the configuration of
default routes. A configured default route is treated exactly like a static route.
Therefore, default routes and static routes have the same default preference.
Commands in this Chapter
This chapter explains the following commands:
encapsulation show ip brief
ip address show ip interface
ip mtu show ip protocols
ip netdirbcast show ip route
ip route show ip route configured
ip route default show ip route summary
ip route distance show ip traffic
ip routing show ip vlan
routing
2CSPC4.XCT-SWUM2XX1.book Page 966 Monday, October 3, 2011 11:05 AM