Steps
1. Reconnect the touchpad FFC to the touchpad module.
2. Align and place the touchpad module onto the system.
3. Install the two (M2x2) screws to secure the touchpad module to the palmrest.
4. Install the touchpad bracket on the touchpad and secure it using the three (M2x2) screws.
5. Peel back the conductive tape over the touchpad module.
6. Reconnect the touchpad FFC to the system board.
Next steps
1. Install the
.
2. Install the
.
3. Install the
.
after working inside your computer
.
Display assembly
Removing the display assembly
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Disconnect the
.
5. Remove the
Disassembly and reassembly
51
Summary of Contents for P90F
