About this task
Steps
1. Slide and insert the Solid-state drive into the M.2 port on the system board.
2. Place the thermal bracket on the solid-state drive, replace the single (M2x2.2) screw and tighten the captive screw to
secure the thermal plate to the palmrest.
Next steps
1. Connect the
.
2. Install the
.
3. Install the
.
after working inside your computer
.
Hard drive
Removing the hard drive assembly
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
Disassembly and reassembly
35
Summary of Contents for P90F
