Dell P132G, Service Manual

Page: 82 / 83

Table 4. LED codes (continued)
Diagnostic light codes Problem description Recommended solutions
2,7 LCD failure - SBIOS message Replace display vable (EDP) if possible,
otherwise replace the display assembly
(LCD).
2,8 LCD failure - EC detection of power rail failure Replace the system board.
3,1 Coin-cell battery failure Reset the CMOS battery connection. If
problem persists, replace the RTC battery.
3,2 PCI, video card/chip failure Replace the system board.
3,3 Recovery image not found Flash latest BIOS version. If problem persists,
replace the system board.
3,4 Recovery image found but invalid Flash latest BIOS version. If problem persists,
replace the system board.
3,5 Power-rail failure EC ran into power sequencing failure. If
problem persists, replace the system board.
3,6 System BIOS Flash incomplete Flash corruption detected by SBIOS. If
problem persists, replace the system board.
3,7 Management Engine (ME) error Timeout waiting on ME to reply to HECI
message. If problem persists, replace the
system board.
Camera status light: Indicates whether the camera is in use.
● Solid white—Camera is in use.
● Off—Camera is not in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.
● Solid white—Caps Lock enabled.
● Off—Caps Lock disabled.
WiFi power cycle
About this task
If your computer is unable to access the internet due to WiFi connectivity issues a WiFi power cycle procedure may be
performed. The following procedure provides the instructions on how to conduct a WiFi power cycle:
NOTE: Some ISPs (Internet Service Providers) provide a modem/router combo device.
Steps
1. Turn off your computer.
2. Turn off the modem.
3. Turn off the wireless router.
4. Wait for 30 seconds.
5. Turn on the wireless router.
6. Turn on the modem.
7. Turn on your computer.
82 Troubleshooting