CAUTION:
To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state.
2. Remove the
.
About this task
NOTE:
Depending on the configuration ordered, your computer may support an M.2 2280 solid-state drive or an M.2 2280
solid-state drive.
NOTE:
This procedure applies only to computers shipped with an M.2 2280 solid-state drive.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the antenna cable from the routing guides along the edge of the solid-state drive shield.
2. Remove the screw (M2x3) that secures the M.2 2280 solid-state drive shield to the system board.
3. Slide and lift the M.2 2280 solid-state drive off the solid-state drive slot on the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
20
Removing and installing components
