Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Slide the M.2 2230 solid-state drive into the solid-state drive slot on the system board.
3. Replace the screw (M2x4) that secures the M.2 2230 solid-state drive to the system board.
Next steps
1. Install the
.
2. Install the
3. Install the
.
After working inside your computer
.
Memory modules
Removing the memory modules
Prerequisites
Before working inside your computer
.
2. Remove the
3. Remove the
.
4. Remove the
.
About this task
The following images indicate the location of the memory modules and provide a visual representation of the removal procedure.
Steps
1. Using your fingertips, spread apart the securing clips on the memory-module slot until the memory module pops up.
2. Slide and remove the memory module from the memory-module slot.
NOTE:
Repeat step 1 and 2 if there are two memory modules.
Removing and installing components
31
Summary of Contents for P104F
