5.
Connect the power and hard-drive cables to the drive.
6.
Check all connectors to be certain that they are properly cabled and firmly seated.
7.
Close the computer cover
.
8.
Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
9.
If the drive you just installed is the primary drive, insert a bootable floppy disk into drive A.
10.
Turn on the computer.
11.
Enter system setup
, and update the appropriate
Primary Drive
option (
0
or
1
).
12.
Exit system setup, and reboot the computer.
13.
Partition and logically format your drive before you proceed to the next step.
See the documentation for your operating system for instructions.
14.
Test the hard drive by running the
Dell Diagnostics
.
15.
If the drive you just installed is the primary drive, install your operating system on the hard drive.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next
computer start-up:
ALERT! Cover was previously removed.
16.
Reset the chassis intrusion detector
by changing
Chassis Intrusion
to
Enabled
or
Enabled-Silent
.
Adding a Second Hard Drive
NOTICE:
Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
1
power cable
2
hard-drive cable
NOTICE:
To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
Summary of Contents for OptiPlex GX60
Page 27: ......
Page 30: ...3 Press Alt b to restart the computer and implement your changes Back to Contents Page ...
Page 140: ...Back to Contents Page ...
Page 174: ......
