Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
NOTE:
Repeat step 1 and 2 if there are two memory modules.
3. Align the tabs on the DIMM door with the slots on the system-board shield and snap it into place.
NOTE:
Repeat step 1 and 2 if there are two memory modules.
Next steps
1. Install the
2. Install the
3. Install the
4. Follow the procedure in
After working inside your computer
.
System-board shield
Removing the system-board shield
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
.
3. Remove the
(optional).
4. Remove the
.
Removing and installing components
29
