4
Install the following components:
a
b
c
d
5
Follow the procedure in
After working inside your computer
.
Power supply unit - PSU
Removing the power supply unit -PSU
1
Follow the procedure in
Before working inside your computer
.
2
Remove the following components:
a
b
c
d
3
To release the PSU cable:
a Remove the single (M3x5) screw securing the power supply socket to the I/O bracket [1].
b Slide the power supply socket away to remove it from the system [2].
c Unroute the power supply cables from the retention clips in the chassis [3].
d Disconnect the power supply cable from the socket on the system board [4].
NOTE:
Press the clip downward to release the power supply cable from the system board.
Removing and Installing components
59
Summary of Contents for OptiPlex 5260
Page 1: ...Dell OptiPlex 5260 All in One Service Manual Regulatory Model W20B Regulatory Type W20B001 ...
Page 57: ...4 Pry and lift the base cover off the middle frame Removing and Installing components 57 ...
Page 61: ...b Slide the PSU and lift it away from the chassis Removing and Installing components 61 ...
