NOTE:
The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the
processor socket. When the processor is properly seated, all four corners are aligned at the same height. If one or
more corners of the processor are higher than the others, the processor is not seated properly.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor cover.
Next steps
1. Install the
processor fan and heat-sink assembly
.
2. Install the
3. Install the
.
4. Follow the procedure in
after working inside your computer
.
Graphics card
Removing the graphics card
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
About this task
The following images indicate the location of the graphics card and provides a visual representation of the removal procedure.
38
Disassembly and reassembly
Summary of Contents for OptiPlex 5080 Tower
