Installing the system fan
1
Insert the grommets into the slots on the chassis frame.
2
Hold the system fan with the cable facing the base of the computer.
3
Align the grooves of the system fan with the grommets on the chassis wall.
4
Pass the grommets through the corresponding grooves on the system fan.
5
Stretch the grommets and slide the system fan toward the computer until it locks into place.
NOTE:
Install the lower two grommets first.
6
Secure the intrusion switch cable to the system fan with an adhesive tape.
7
Connect the system fan cable to the connector on the system board.
8
Close the front panel door.
9
Install the:
a
b
10 Follow the procedure in
After working inside your computer
.
VGA Daughterboard
Removing the VGA daughter board
1
Follow the procedure in
Before Working Inside your Computer
2
Remove the:
a
b
3
4
To remove the VGA daughter board:
a Remove the screws that secure the VGA connector to the computer [1].
b Slide the VGA connector to release it from the computer [2].
c Remove the screw that secures the VGA daughter board to the computer [3].
d Lift the VGA daughter board using the handle to remove it from the computer [4].
40
Disassembly and reassembly
Summary of Contents for OptiPlex 5055 Tower
Page 1: ...Dell OptiPlex 5055 Tower Owner s Manual Regulatory Model D18M Regulatory Type D18M004 ...
Page 12: ...4 Lift the front bezel to remove it from the computer 12 Disassembly and reassembly ...
Page 44: ...b Slide and lift the system board away from the computer 2 44 Disassembly and reassembly ...
