Optional GPU card
Removing the optional GPU card
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
before working inside your system
.
3. If installed,
4. If installed,
5. If installed,
remove the expansion card holder.
NOTE:
The optional GPU card images below are representative and may not match the actual optional GPU card to
remove.
Steps
1. Press the expansion card latch and push down the latch to open it. Hold the GPU card by the edges, and pull the card until
the card edge connector disengages from the connector on the expansion card slot.
Figure 80. Removing optional GPU card
2. If you are removing the GPU card permanently, install a metal filler bracket over the empty slot opening, and close the
expansion card latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system . The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system . The filler bracket is necessary to maintain proper thermal conditions.
Installing and removing system components
95
Summary of Contents for Olympus O-T600
Page 21: ...Figure 16 Configuration and layout 20 Dell EMC PowerEdge T640 overview ...
Page 22: ...Figure 17 Electrical overview Dell EMC PowerEdge T640 overview 21 ...
Page 23: ...Figure 18 Memory information 22 Dell EMC PowerEdge T640 overview ...
Page 24: ...Figure 19 System tasks Dell EMC PowerEdge T640 overview 23 ...
