Installing the optional iDRAC port card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1.
Ensure that you follow the
.
2.
Follow the procedure listed in
Before working inside your system
3.
Keep the Phillips #2 screwdriver ready.
4.
Remove the cooling shroud.
Steps
1.
Align and insert the tabs on the iDRAC port card into the slots on the chassis.
2.
Insert the iDRAC port card into the connector on the system board.
3.
Tighten the screw that secures the iDRAC port card holder to the system board.
Next steps
1.
Install the cooling shroud.
2.
If disconnected, reconnect the network cable.
3.
Follow the procedure listed in
After working inside your system
.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Internal dual SD module (optional)
The Internal Dual SD Module (IDSDM) card provides two SD card slots. This card offers the following
features:
• Dual card operation — maintains a mirrored configuration by using SD cards in both the slots and
provides redundancy.
NOTE: When the
Redundancy
option is set to
Mirror Mode
in the
Integrated Devices
screen of
System Setup, the information is replicated from one SD card to another.
• Single card operation — single card operation is supported, but without redundancy.
Removing an optional internal SD card
Prerequisites
1.
Follow the safety guidelines listed in Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
93
