15
| W-7024 Controller
Dell Networking W-7024 Controller | Installation Guide
LCD Mode
Function
Displayed Status/ Command
Description
Status
Displays the ArubaOS version.
OS Version
ArubaOS version
Exit
Exit Status menu
Maintenance
Allows execution of some basic
operations such as uploading an
image or rebooting the controller.
Upgrade Image [Partition 0 [Y|N] |
Partition 1 [Y|N]]
Upgrade the controller image on
the selected partition from a
predefined location on an
attached USB flash device
Upload config [Y | N]
Upload the controller’s current
configuration to a predefined
location on the attached USB
flash device
Factory Default [Y|N]
Reset the controller to factory
default settings
Media Eject [Y| N]
Complete reading or writing to
the attached USB device
Reload system [Y|N]
Reload controller
Halt system [Y|N]
Halt controller
Exit
Exit Maintenance menu
Table 11:
LCD Panel Mode
Disabling the LCD Screen
By default, the LCD screen is enabled. However, if the W-7024 controller is deployed in a location without physical
security, the LCD screen can be disabled through the CLI. When disabled, pushing one of the navigation buttons
will only illuminate the LCD screen and display the slot, role, device name, and any alarms.
Additionally, it is possible to disable only the maintenance menu. This allows to change the LED behavior and view
the device status but prevent upgrades and configuration changes.
To disable the LCD screen, enter the Enable mode and use the following CLI commands:
(host) #configure terminal
(host) (config) #lcd-menu
(host) (lcd-menu) #disable menu
To disable only the Maintenance menu or one of its sub-menus, enter the Enable mode and use the following CLI
commands:
(host) #configure terminal
(host) (config) #lcd
(host) (lcd-menu) #disable menu maintenance ?
factory-default
halt-system
media-eject
reload-system
upgrade-image
upload-config
(host) (lcd-menu) #disable menu maintenance upgrade-image ?
partition0
partition1
