Dell Networking S6000 System, Reference Manual, Page: 981 / 1510

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information The
distribute-list out
command applies to routes autonomous system
boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type
2 and external type 1 routes, but not to intra-area and inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
S6000
Syntax
fast-convergence { number }
To cancel fast-convergence, use the
no fast convergence
command.
Parameters
number Enter the convergence level desired. The higher this
parameter is set, the faster OSPF converge takes place. The
range is from 1 to 4.
Defaults none.
Command
Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on all platforms.
Usage
Information
The higher this parameter is set, the faster OSPF converge takes place.
NOTE: The faster the convergence, the more frequent the route calculations
and updates. This behavior impacts CPU utilization and may impact adjacency
stability in larger topologies.
Open Shortest Path First (OSPFv2 and OSPFv3)
981