Dell Networking S6000 System, Reference Manual, Page: 871 / 1510

mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
S6000
Syntax
mac learning-limit reset
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
show mac-address-table
Display the MAC address table.
S6000
Syntax show mac-address-table [address mac-address | interface
interface | vlan vlan-id ] [aging-time] [dynamic | static]
[count [vlan vlan-id ] [interface interface-type [ slot [ /
port ]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword
address
then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
dynamic (OPTIONAL) Enter the keyword
dynamic
to display only
those MAC addresses the switch dynamically learns.
Optionally, you can also add one of these combinations:
address/ mac-address
,
interface/ interface
, or
vlan
vlan-id
.
Layer 2
871