Dell Networking S6000 System, Reference Manual

Page: 833 / 1510

Defaults narrow ; if no Level is specified, Level-1 and Level-2 are configured.
Command
Modes ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0 Introduced on the S4810.
Usage
Information
If you enter the
metric-style wide
command, the Dell Networking OS
generates and accepts only new-style TLVs. The router uses less memory and
other resources rather than generating both old-style and new-style TLVs.
The new-style TLVs have wider metric fields than old-style TLVs.
Related
Commands isis metric — configures a metric for an interface.
multi-topology
Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix
information in the LSPs.
S6000
Syntax
multi-topology [transition]
To return to a single topology configuration, use the
no multi-topology
[transition]
command.
Parameters
transition
Defaults Disabled
Command
Modes CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
Intermediate System to Intermediate System (IS-IS)
833