Dell Networking S6000 System, Reference Manual

Page: 830 / 1510

max-area-addresses
Configure manual area addresses.
S6000
Syntax
max-area-addresses number
To return to the default values, use the
no max-area-addresses
command.
Parameters
number Set the maximum number of manual area addresses. The
range is from 3 to 6. The default is
3 .
Defaults 3 addresses
Command
Modes ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.5.1.0 Added support for LSP Throttling Enhancement.
Usage
Information To configure the number of area addresses on router, use this command. This
value must be consistent with routers in the same area, otherwise the router forms
only Level 2 adjacencies. The value must be same among all the routers to form
Level 1 adjacencies.
max-lsp-lifetime
Set the maximum time that link-state packets (LSPs) exist without being refreshed.
S6000
Syntax
max-lsp-lifetime seconds
To restore the default time, use the
no max-lsp-lifetime
command.
830
Intermediate System to Intermediate System (IS-IS)