Dell Networking S6000 System, Reference Manual, Page: 810 / 1510

graceful-restart t3
Configure the overall wait time before graceful restart completes.
S6000
Syntax
graceful-restart t3 {adjacency | manual} seconds
To return to the default, use the
no graceful-restart t3
command.
Parameters
adjacency Enter the keyword
adjacency
so that the restarting router
receives the remaining time value from its peer and adjusts
its T3 value so if you have configured this option.
manual Enter the keyword
manual
to specify a time value that the
restarting router uses. The range is from 50 to 120 seconds.
The default is
30 seconds .
Defaults manual, 30 seconds
Command
Modes ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Introduced on the E-Series.
Usage
Information
The running router sets the remaining time value to the current adjacency hold
time. You can override this setting by implementing this command.
Override the default restart-wait time by entering the
no graceful-restart
restart-wait
command. When you disable
restart-wait
, the current
adjacency hold time is used.
Set the t3 timer to
adjacency
on the restarting router when implementing this
command. The restarting router gets the remaining time value from its peer and
adjusts its T3 value so only when you have configured
graceful-restart t3
adjacency
.
810
Intermediate System to Intermediate System (IS-IS)