Dell Networking S6000 System, Reference Manual, Page: 784 / 1510

ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet
is dropped.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Added support for CoPP for OSPFv3 on the S4810, S4820T,
S6000, and Z9000 platforms.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, names
are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your line card documentation.
You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in
addition to the CoPP support for VRRP, BGP, and ICMP.
cam-acl-egress
Allocate space for IPv6 egress ACLs.
S6000
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4 }
Parameters
default Use the default CAM profile settings, and set the CAM as
follows:
• L2 ACL(l2acl): 1
784
IPv6 Access Control Lists (IPv6 ACLs)