Dell Networking S6000 System, Reference Manual, Page: 759 / 1510

static (OPTIONAL) Enter the keyword
static
to view non-active
routes also.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Example
Dell#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
Dell#
show ipv6 management-route
Display the IPv6 static routes configured for the management interface.
S6000
Syntax show ipv6 management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword
all
to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword
connected
to view only
routes directly connected to the Management interface.
IPv4 Routing
759