Dell Networking S6000 System, Reference Manual

Page: 754 / 1510

BLK HOLE 0 0
Dell>
Related
Commands clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S6000
Syntax
show ip flow interface interface {source-ip address
destination-ip address } {protocol number [tcp | udp]} {src-port
number destination-port number }
Parameters
interface
interface
Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
source-ip
address
Enter the keywords
source-ip
then the IP source address
in IP address format.
destination-ip
address
Enter the keywords
destination-ip
then the IP
destination address in IP address format.
protocol
number [tcp |
udp]
Enter the keyword
protocol
then one of the protocol type
keywords:
tcp
,
udp
, or
protocol number
The protocol
number range is from 0 to 255. .
src-port
number
Enter the keywords src-port then the source port number.
destination-
port
number
Enter the keywords destination-port then the destination
port number.
Command
Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
754
IPv4 Routing