Dell Networking S6000 System, Reference Manual

Page: 750 / 1510

show ip cam stack-unit
Display CAM entries for an S-Series or Z-Series switch.
S6000
Syntax
show ip cam stack-unit { id } [port-set { pipe-number } | hostname
{ ip-address mask [longer-prefixes [ecmp-group detail]]}| ecmp-
group {detail | member-info [detail [group-index index-
number ]]}| summary]
Parameters
id Enter the stack-unit ID. The unit ID range is from 0 to 7 for
the S6000.
port-set pipe-
number
Enter the keyword
port-set
then the number of the stack
unit’s port-pipe. The unit ID range is from 0 to 0 for the
S6000.
hostname Enter the hostname in A.B.C.D format.
network mask
[longer-
prefixes [ecmp-
group detail]]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. You can enter one of the
following keywords to filter results.
• Enter the keyword
longer-prefixes
to view routes
with a common prefix.
• Enter the keyword
ecmp-group detail
to view the
ECMP group index.
ecmp-group
{detail |
member-info
[detail [group-
index
index-
number ]]}
(OPTIONAL) Enter the keyword
ecmp-group
then one of the
following keywords to filter results.
• Enter the keyword
detail
to view the ECMP group
index.
• Enter the keyword
member-info
to view the member
information for the ECMP group.
• Enter the keyword
member-info detail
to view
detailed ECMP membership and n-hop information.
• Enter the keyword
group-index
then the index number
to show ECMP membership per group. The range is from
0 to 1022.
summary (OPTIONAL) Enter the keyword
summary
to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
750
IPv4 Routing