Dell Networking S6000 System, Reference Manual

Page: 743 / 1510

management route
Configure a static route that points to the Management interface or a forwarding router.
S6000
Syntax
management route {{ ip-address mask | { ipv6-address prefix-
length }} { forwarding-router-address | managementethernet}
To remove a static route, use the
no management route{{ ip-address mask
| { ipv6-address prefix-length }}{ forwarding-router-address |
managementethernet}
command.
Parameters
ip-address
mask Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
ipv6-address
prefix-length Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
forwarding-
router-address Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
managementet
hernet Enter the keyword
managementethernet
for the
Management interface on the Primary RPM.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000 and added support for IPv6.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
IPv4 Routing
743