Dell Networking S6000 System, Reference Manual

Page: 736 / 1510

Defaults Enabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
ip tcp initial-time
Define the wait duration in seconds for the TCP connection to be established. This command is
supported on the , , S6000, and platforms.
Syntax
ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as 8
seconds, use the
no ip tcp initial-time
command
Parameters
<8-75> Wait duration in seconds for the TCP connection to be
established.
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the S4810, S4820T, S6000, and Z9000
platforms.
Usage
Information You can configure the amount of time for which the device must wait before it
attempts to establish a TCP connection. Using this capability, you can limit the wait
times for TCP connection requests. Upon responding to the initial SYN packet that
requests a connection to the router for a specific service (such as SSH or BGP) with
736
IPv4 Routing