Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
ttl
(OPTIONAL) Enter the number of hops as the Time to Live
(ttl) value. The range is from 1 to 255. The default is
255
.
Defaults
Disabled.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 7.8.1.0
Introduced on the S-Series.
Version 7.7.1.0
Introduced on the C-Series.
Usage
Information
To prevent loops, the
neighbor ebgp-multihop
command does not install the
default routes of the multihop peer. Networks not directly connected are not
considered valid for best-path selection.
neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
S6000
Syntax
neighbor {
ipv4-address
|
peer-group-name
} fall-over
To disable, use the
no neighbor {
ipv4-address
|
peer-group-name
}
fall-over
command.
Parameters
ipv4-address
Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
Border Gateway Protocol
369
Summary of Contents for Networking S6000 System
