Dell Networking S6000 System, Reference Manual

Page: 243 / 1510

match route-type
To match routes based on the how the route is defined, configure a filter.
S6000
Syntax
match route-type {external [type-1 | type-2] | internal |
level-1 | level-2 | local}
To delete a match, use the
no match route-type {local | internal |
external [type-1 | type-2] | level-1 | level-2}
command.
Parameters
external
[type-1| type-2] Enter the keyword
external
then either type-1 or type-2 to
match only on OSPF Type 1 routes or OSPF Type 2 routes.
internal Enter the keyword
internal
to match only on routes
generated within OSPF areas.
level-1 Enter the keyword
level-1
to match IS-IS Level 1 routes.
level-2 Enter the keyword
level-2
to match IS-IS Level 2 routes.
local Enter the keyword
local
to match only on routes generated
within the switch.
Defaults Not configured.
Command
Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
Access Control Lists (ACL)
243