Dell Networking S6000 System, Reference Manual

Page: 163 / 1510

Where the default values are as follows:
dot1x server-timeout
(30 seconds),
radius-server retransmit (3 seconds), and radius-server timeout (5 seconds).
For example:
Dell(conf)#radius-server host 10.11.197.105 timeout 6
Dell(conf)#radius-server host 10.11.197.105 retransmit 4
Dell(conf)#interface gigabitethernet 2/23
Dell(conf-if-gi-2/23)#dot1x server-timeout 40
dot1x supplicant-timeout
Configure the amount of time after which exchanges with the supplicant time-out.
S6000
Syntax
dot1x supplicant-timeout seconds
To return to the default, use the
no dot1x supplicant-timeout
command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30 .
Defaults 30 seconds
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
802.1X
163