Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 7.6.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Changing the value of the SNMP Engine ID has important side effects. A user’s
password (entered on the command line) is converted to a message digest
algorithm (MD5) or secure hash algorithm (SHA) security digest. This digest is based
on both the password and the local Engine ID. The command line password is then
destroyed, as required by RFC 2274. Because of this deletion, if the local value of
the Engine ID changes, the security digests of SNMPv3 users is invalid and the users
will have to be reconfigured.
For the remote Engine ID, the host IP and UDP port are the indexes to the
command that are matched to either overwrite or remove the configuration.
Related
Commands
— displays the SNMP engine and all the remote engines that
are configured on the router.
snmp — displays the SNMP running configuration.
snmp-server group
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
S6000
Syntax
snmp-server group [
group_name
{1 | 2c | 3 {auth | noauth |
priv}}] [read
name
] [write
name
] [notify
name
] [access
access-
list-name
| ipv6
access-list-name
|
access-list-name
ipv6
access-list-name
]]
To remove a specified group, use the
no snmp-server group [
group_name
{v1 | v2c | v3 {auth | noauth | priv}}] [read
name
] [write
name
] [notify
name
] [access
access-list-name
| ipv6
access-
list-name
|
access-list-name
ipv6
access-list-name
]]
command.
Parameters
group_name
Enter a text string (up to 20 characters long) as the name of
the group. The following groups are created for mapping to
read/write community/security-names (defaults):
Simple Network Management Protocol (SNMP) and Syslog
1343
Summary of Contents for Networking S6000 System
