Dell Networking S6000 System, Reference Manual

Page: 1324 / 1510

Defaults Disabled.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information When you enable sFlow on an interface, flow sampling is done on any traffic going
out of the interface.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
Related
Commands sflow enable (Global) — turns sFlow on globally.
sflow extended-switch enable
Enable packing information on a switch only.
S6000
Syntax
sflow extended-switch enable
To disable packing information, use the
no sflow extended-switch [enable]
command.
Parameters
enable Enter the keyword
enable
to enable global extended
information.
1324
sFlow