Dell Networking S6000 System, Reference Manual

Page: 1119 / 1510

Version 8.3.7.0 Introduced on the S4810.
pre-Version
7.7.1.0 Introduced.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
qos-policy-input — creates an input QoS-policy on the router.
qos-policy-output — creates an output QoS-policy on the router.
wred-profile — creates a WRED profile.
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-
any class-maps on both ACLs as well as VLANs.
S6000
Syntax
match ip access-group access-group-name [set-ip-dscp value |
set-color value ]
To remove ACL match criteria from a class map, use the
no match ip access-
group access-group-name [set-ip-dscp value | set-color value ]
command.
Parameters
access-group-
name Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the
class-map specifies.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
set-color value (Optional) Enter the keyword set-color followed by a color
value. Traffic that fulfills the match criteria is marked with the
color value that you specify. The default value is Yellow.
Defaults none
Command
Modes CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Quality of Service (QoS)
1119