The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the S4810.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.1.1.0
Introduced on the E-Series ExaScale.
Version 7.7.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
Version 7.4.1.0
Introduced on the E-Series.
Usage
Information
The
monitoring
command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Example
Dell(conf-mon-sess-0)#do show running-config monitor session
!
monitor session 0
source Port-channel 10 destination TenGigabitEthernet 0/33
direction tx
!
Related
Commands
— creates a session for monitoring.
— displays a monitor session.
source (port monitoring)
Configure a port monitor source.
S6000
Syntax
source
interface
|
range
destination
interface
direction {rx |
tx | both}
To disable a monitor source, use the
no source
interface
destination
interface
direction {rx | tx | both}
command.
Parameters
source
interface
Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Port Monitoring
1081
Summary of Contents for Networking S6000 System
