Dell Networking S6000 System, Reference Manual, Page: 1067 / 1510

To disable PIM sparse mode and IGMP, use the
no ip pim sparse-mode
command.
Defaults Disabled.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
Usage
Information The interface must be enabled (the
no shutdown
command) and not have the
switchport
command configured. Multicast must also be enabled globally (using
the
ip multicast-lag-hashing
command). PIM is supported on the port-
channel interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs an access list defines.
S6000
Syntax
ip pim sparse-mode sg-expiry-timer seconds [access-list name]
To disable configured timers and return to default mode, use the
no ip pim
sparse-mode sg-expiry-timer
command.
Parameters
seconds Enter the number of seconds the S, G entries are retained.
The range is from 211 to 86400.
access-list
name (OPTIONAL) Enter the name of a previously configured
Extended ACL to enable the expiry time to specified S,G
entries.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command
Modes CONFIGURATION
PIM-Sparse Mode (PIM-SM)
1067