source
Enter the IP address of the network or host from which the
packets were sent.
mask
Enter a network mask in /prefix format (/x).
any
Enter the keyword
any
to specify that all traffic is subject to
the filter.
host
ip-address
Enter the keyword
host
then the IP address to specify a host
IP address.
destination
Enter the IP address of the network or host to which the
packets are sent.
operator
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
command parameter.)
Defaults
none
Command
Modes
REDIRECT-LIST
Command
History
Version 9.4.0.0
Introduced on the S6000.
Version 8.4.2.1
Introduced on the C-Series.
Version 8.4.2.0
Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
S6000
Syntax
seq
sequence-number
{permit | redirect {
ip-address
}} {
ip-
protocol-number
|
protocol-type
} {
source mask
| any | host
ip-
address
} {
destination mask
| any | host
ip-address
} [bit]
[
operator
]{source-port
source-port
| source-port-range
start-
port - end-port
} {destination-port
destination-port
|
destination-port-range
start-port - end-port
}
To delete a filter, use the
no seq sequence-number
command.
Policy-based Routing (PBR)
1051
Summary of Contents for Networking S6000 System
