Dell N1100-ON, Reference Manual

Page: 963 / 2332

Security Commands
963
Default Configuration
The default for this command is disabled.
Command Mode
Global Configuration mode
User Guidelines
Devices connected to interfaces on which IEEE 802.1X authentication is
enabled will be required to authenticate before accessing network resources.
This command enables local processing of IEEE 802.1x frames on the switch.
Dot1x eapolflood mode must be disabled for local processing to occur.
If 802.1x is used in combination with the authentication manager, be sure to
enable the authentication manager with the authentication enable
command.
Example
The following example enables 802.1x globally.
console(config)# dot1x system-auth-control
dot1x system-auth-control monitor
Use the dot1x system-auth-control monitor command in Global
Configuration mode to enable 802.1x monitor mode globally. To disable this
function, use the no form of this command.
Syntax
dot1x system-auth-control monitor
no dot1x system-auth-control monitor
Default Configuration
Dot1x monitor mode is disabled.
Command Mode
Global Configuration mode