Dell N1100-ON, Reference Manual

Page: 816 / 2332

Layer 2 Switching Commands
816
Default Configuration
The default value for the vlan-id parameter is 1 when the VLAN is enabled.
Otherwise, the value is 4093.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
User Guidelines
Setting a new PVID does NOT remove the previously configured PVID VLAN
from the port membership.
Example
The following example shows how to configure the PVID for 1/0/8, when the
interface is in general mode.
console(config)#interface gigabitethernet 1/0/8
console(config-if-Gi1/0/8)#switchport general pvid 234
switchport mode
Use the switchport mode command in Interface Configuration mode to
configure the VLAN membership mode of a port. To reset the mode to the
appropriate default for the switch, use the no form of this command.
Syntax
switchport mode { access | trunk | general }
no switchport mode
• access —An access port connects to a single end station belonging to a
single VLAN. An access port is configured with ingress filtering enabled
and will accept either an untagged frame or a packet tagged with the access
port VLAN. Tagged packets received with a VLAN other than the access
port VLAN are discarded. An access port transmits only untagged packets.
• trunk —A trunk port connects two switches. A trunk port may belong to
multiple VLANs. A trunk port accepts only packets tagged with the VLAN
IDs of the VLANs to which the trunk is a member or untagged packets if